This is a 4-channel wireless remote control replacement for garage doors, electronic gate doors, alarm systems, cars, car alarms, home alarms, panic buttons, garage doors, rolling curtain, etc. It’s a fixed frequency frequency meter (we offer both 315Mhz and 433Mhz) for cloning 99.99% common fixed and learning code remote controls. 4-channel means it’s able to be used to clone up to 4 remote signals from 4 different remotes (use one remote to control 4 gate doors)!
Color: Black and Silver w/ metal key ring
Quantity: 1 pc
Size: 5.5 x 3.3 x 1.6 cm (LxWxH)
Operating frequency: 433.92MHz/315Mhz fixed frequency
Distance: Up to 100 meters
With this replacement remote key you can clone all 315Mhz/433.92MHz fixed code key fobs based on supported chip codes: PT2240, PT2260, EV1527, PT2262, FP527, AX5326, PT2262, PT2242, HT6207, HT6010, HT6012, HT6014, AX5326-4, SMC5026, SMC5326-3, SMC918, SMC918-3, SMC918-4, HT680, HT600 etc… You can check CHIP CODE from your original remote to see if the replacement is supported and compatible.
Look at the above image for an example, the chip code can be same or different, important numbers only.
Note: Rolling code remotes is incompatible.
Metal frame and durable plastic case make it sturdy and durable
Button slide cover to protect buttons avoid accidental unplanned operation
You can still keep & use your original factory remotes as well as what a bonus
Codes into your garage door in less than 30 seconds
Handy key chain size attaches to your car keys no more unwanted bulkiness
Press and hold LOCK and UNLOCK keys at the same time until the blue LED flashes for 3 times, now keep holding the LOCK key, and press UNLOCK key for 3 times slowly within 5 seconds until LED flashes quickly and continuously, now release all keys (This step is to clear existing code in the replacement remote).
Take the original remote in your left hand, while the cloner on your right hand, put them close together/side by side so that they are touching. Simultaneously press a button on your original remote key and one of the buttons on the replacement and hold them until the blue light on the cloner flashes steadily. (The Blue Light will first flash 3 times quick, then stops for a second, and then flashes steadily when cloned successfully).
Programming is now successful! If you want to program more buttons simply repeat steps 2. It’s that easy! To reset the remote simply start again with step 1. If you reset your replacement remote key incautiously or if you want to discard all changes, just press the two bottom buttons (MUTE & LIGHTING) for about 3 seconds until the blue light flashes quickly.
BATTERY SAVING MODE
Press ANY key or multi-keys at the same time for 15 seconds, the remote will stop working to save battery power.
1* Replacement Remote Controller Duplicator (with battery included)